Custom Resin Designs Questions

Yes, but every color in the blend must be UV-tested at Front Range elevation before the installer finalizes the scheme. Skipping that step is why multi-tone surfaces fade unevenly. The written quote confirms which aggregates passed testing before any work begins.

Freeze-thaw cycles widen any lifted edge each winter. A small gap in an inlay border becomes a full section failure within two seasons, and the sub-base beneath it erodes further with each snowmelt cycle. Early intervention costs significantly less than a full re-lay.

A custom design has more joints and transitions, so the sub-base must be uniform in depth across the entire area, not just the main run. The installer checks for any variation before laying begins, because an uneven base causes inlay borders to crack first.

Resin-bound surfaces are SUDS-compliant and allow water to pass through to a prepared drainage layer beneath. On Foothills slopes, the installer specifies the drainage layer depth to handle snowmelt volume, and that detail is included in the written quote.

Design complexity adds time at the specification and layout stage, not necessarily at the laying stage. The installer confirms the timeline in the written quote once the aggregate blend, inlay pattern, and sub-base scope are agreed.

Only if the existing base is structurally sound, level, and free of frost heave damage. The installer assesses the base during the site visit and specifies any remediation needed. Laying over a compromised base voids the performance of the new surface.